EasyManua.ls Logo

JVC GR-DVL505

JVC GR-DVL505
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN33
PLAYBACK
Basic Playback For Video
P
L
A
Y
O
F
F
Power Switch
Rewind Button (
2
)
Fast-Forward Button
(
3
)
Play/Pause Button
(
4
/6)
Stop Button (5)
1
Load a tape ( pg. 12).
2
Set the VIDEO/DSC Switch to VIDEO, then set the
Power Switch to while pressing down the
Lock Button located on the switch. To start playback,
press
4
/6.
To stop playback, press 5.
Press
2
to rewind, or
3
to fast-forward the tape
during Stop mode.
To Control The Speaker Volume . . .
.... slide the Power Zoom Lever (VOL.) towards + to
turn up the volume, or towards to turn down the
volume.
NOTES:
If Stop mode continues for 5 minutes when power is
supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch to
OFF, then to .
The playback picture can be viewed in the LCD monitor,
viewfinder or on a connected TV (
pg. 42).
You can also view the playback picture on the LCD
monitor with it flipped over and pushed against the
camera body.
LCD monitor/viewfinder indications:
When power is supplied from a battery: the
battery pack remaining power indicator is displayed.
When power is supplied through the DC cord:
does not appear.
During Stop mode, none of the indications are
displayed.
When a cable is connected to the AV connector, the
sound is not heard from the speaker.
Power Zoom
Lever (VOL.)
Speaker
Lock Button
Still Playback:
Pauses during playback.
1) Press
4
/6 during playback.
2) To resume normal playback, press
4
/6 again.
If still playback continues for more than about 3 minutes, the camcorders Stop mode is automatically
engaged. After 5 minutes in the Stop mode, the camcorders power is automatically turned off.
When
4
/6
is pressed, the image may not pause immediately while the camcorder stabilizes the still
image.
Shuttle Search:
Allows high-speed search in either direction.
1) Press
3
for forward or
2
for reverse search during playback.
2) To resume normal playback, press
4
/6.
During playback, press and hold
2
or
3
. The search continues as long as you hold the button.
Once you release it, normal playback resumes.
A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction.
Frame-By-Frame Playback: Allows frame-by-frame search.
1) Engage Still Playback.
2) Rotate the MENU/BRIGHT wheel towards + for forward Frame-By-Frame Playback, or towards for
reverse Frame-By-Frame Playback during Still Playback.
To resume normal playback, press
4
/6.
You can also use the provided remote control for Frame-By-Frame Playback (
pg. 52).
Playback Zoom and Playback Special Effects
Available only with the remote control (provided) ( pg. 52, 53).
VIDEO/DSC Switch (Open the
LCD monitor to access this switch)

Table of Contents

Related product manuals