JVC GR-DVM90

10 EN
Grip Adjustment
1
Separate the Velcro strip.
2
Pass your right hand through the loop and grasp
the grip.
3
Adjust so that your thumb and fingers can easily
operate the START/STOP Button and Power
Zoom Lever. Refasten the Velcro strip.
Viewfinder Adjustment
1
1
Set the POWER Switch to “ ” while
pressing down the Lock Button located on the
switch and set the MODE Dial to any position.
2
Pull out the viewfinder fully.
3
Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused.
START/STOP
Button
Power Zoom Lever
Diopter Adjustment
Control
POWER Switch
GETTING STARTED (cont.)
MODE Dial
CAUTION:
When using a tripod, be sure to open and
extend its legs fully to stabilize the
camcorder. To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod.
Tripod Mounting
1
Align the screw on the tripod with the camera’s
mounting socket. Then tighten the screw.
Lock Button