EasyManua.ls Logo

JVC GR-DVP5

JVC GR-DVP5
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 15
Master Page: Right
GR-DVP7-5EG_09-17.fm Page 15
The date/time is recorded onto the tape at all times,
but its display can be turned on or off during
playback. ( pg. 38, 48)
1 Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
2 Open the LCD monitor fully, or pull out the
viewfinder fully.
3 Press MENU. The Menu Screen appears.
4 Press + or to select “n DISPLAY”, and press
SET/SELECT. The DISPLAY Menu appears.
5 Press + or to select “CLOCK ADJ.”, and press
SET/SELECT. The parameter for “Day” is
highlighted.
6 Press + or to input the day, and press SET/
SELECT. Repeat to input the month, year, hour
and minute.
7 Press + or to select “BRETURN”, and press SET/
SELECT twice. The Menu Screen closes.
Built-in Clock’s Rechargeable Lithium Battery
To store the date/time in memory, the clock’s
rechargeable lithium battery is integrated in the
camcorder. While the camcorder is connected to an
AC outlet using the AC Power Adapter/Charger, or
while the battery pack attached to the camcorder
continues to supply power, the clock’s rechargeable
lithium battery is always charged. However, if the
camcorder is not used for approx. 3 months, the
clock’s lithium battery will become discharged and
the date/time stored in memory will be lost. When
this occurs, first connect the camcorder to an AC
outlet using the AC Power Adapter/Charger for over
24 hours to charge the clock’s rechargeable lithium
battery. Then perform the date/time setting before
using the camcorder.
Note that the camcorder can be used without setting
the date/time.
NOTE:
Even if you select “CLOCK ADJ.”, if the parameter is
not highlighted, the camcorder’s internal clock
continues to operate. Once you move the highlight
bar to the first date/time parameter (day), the clock
stops. When you finish setting the minute and press
SET/SELECT, the date and time begin operation from
the date and time you have just set.
Date/Time Settings
POWER Lamp
Power Switch
Lock Button
MENU Button
SET/SELECT Button
+, – Button
OF
F
FADER
/ W I P E
AM AEPROGR
ACAMER
LMANUA
MSYSTE
DSC
END
AYDISPL
C
AN E
W. BAL
RE NEON SC
LCD / TV
UAOT
IMETDA T E /
T I ME CODE
CLOCK
ADJ .
–FFO
NRETUR
12 .
:
.02
02
17
30
CLOCK
ADJ .
12 .
:
.02
02
17
30
GR-DVP7-5EG_09-17.fm Page 15 Tuesday, March 26, 2002 1:26 PM

Table of Contents

Related product manuals