EN 7
Master Page: Right
GR-DVP7-5EG_02-08.fmPage 7
How To Attach The Strap
1) Thread one end of the strap through the eyelet,
then pass the other end through the loop.
2) Attach the screw to the tripod mounting socket.
To tighten the screw firmly, use a coin, etc.
3) Adjust the length with the adjuster.
NOTES:
● You can use the strap as a shoulder strap by
adjusting the length with the adjuster.
● Because the screw may cause damage to the
camcorder, make sure to attach the screw to the
tripod mounting socket when carrying the
camcorder.
● Use the strap only with this camcorder.
● Do not grip the camcorder too firmly when the
screw is attached. Doing so may cause damage to
the tripod mounting socket.
GR-DVP7-5EG_02-08.book Page 7 Thursday, February 28, 2002 11:39 AM
To Next Page
Loading...
