8 EN
Master Page: Left
GR-DVP7-5EG_02-08.fmPage 8
Automatic Demonstration
Automatic Demonstration takes place when “DEMO
MODE” is set to “ON” (factory-preset).
䡲 Automatic Demonstration starts when there is no
operation for about 3 minutes after the Power Switch is
set to “A” or “M” and no cassette is in the camcorder.
䡲 Performing any operation during the demonstration
stops the demonstration temporarily. If no operation is
performed for more than 3 minute after that, the
demonstration will resume.
䡲 “DEMO MODE” remains “ON” even if the camcorder
power is turned off.
䡲 To cancel Automatic Demonstration:
1) Set the Power Switch to “M” while pressing down the
Lock Button located on the switch.
2) Open the LCD monitor fully, or pull out the viewfinder
fully.
3) Press MENU. The Menu Screen appears.
4) Press + or – to select “s SYSTEM”, and press SET/
SELECT. The SYSTEM Menu appears.
5) Press + or – to select “DEMO MODE”, and press SET/
SELECT. The Sub Menu appears.
6) Press + or – to select “OFF”, and press SET/SELECT.
7) Press + or – to select “BRETURN”, and press SET/
SELECT twice. The normal screen appears.
NOTE:
Slide the lens cover down to see the actual changes of the
Automatic Demonstration activated on the LCD monitor
or viewfinder.
MOD EDEMO –
ON
OFF
Power Switch
Lock Button
MENU Button
Sub Menu
SET/SELECT Button
+, – Button
GR-DVP7-5EG_02-08.book Page 8 Thursday, February 28, 2002 11:39 AM
To Next Page
Loading...
Need help?
General
