24 EN
F
O
C
U
S
B
A
C
K
L
I
G
H
T
E
X
P
O
S
U
R
E
RECORDING
Advanced Features For Video And D.S.C. (cont.)
Dual Shooting
Lets you record images on a tape and store still images in a
MultiMediaCard simultaneously. In other words, it is
possible to store still images in the MultiMediaCard
without interrupting image recording on the tape.
1
Set the POWER Switch to “ ” while pressing
down the Lock Button located on the switch and the
MODE Dial to “
DUAL
” . Pull out the viewfinder fully
or open the LCD monitor fully.
2
While recording to a tape, press SNAPSHOT halfway.
A still image is displayed in the lower right corner of
the screen where the video image being recorded is
displayed.
•At this moment, if you release SNAPSHOT,
snapshot recording will be cancelled.
3
Press SNAPSHOT fully. The displayed still image is
stored in the MultiMediaCard.
NOTES:
●
If SNAPSHOT is pressed in the Record-Standby mode,
only a still image is stored in the MultiMediaCard. Video
recording does not take place.
●
If SNAPSHOT is pressed when “DIS” is set to “ON”
(
pg. 28), the Stabiliser will be disabled.
●
The Stabiliser is less effective in the DUAL mode than in
other modes.
●
The flash is disabled during video recording.
●
Still images are stored in the MultiMediaCard in VGA
mode file size (
pg. 15).
●
When the MODE Dial is set to “DUAL”, all Fade/Wipe
Effects and some Programme AE with special effects
cannot be used (
pg. 34 – 36).
MODE Dial
Operation Switch
Lock Button
FOCUS Button (
3
)
SNAPSHOT Button
MENU Wheel
Video image
Half-pressed
position
Still image
Fully-pressed
position
Released position
POWER Switch
To Next Page
Loading...
Need help?
General
