Allowsyoutosetthetapelengthdependingonthe
tapeused:T20=20minutes,T30=30minutes,
T35=35minutes,T40=40minutes,
•Taperemainingtime_ iscorrectonlyifthe
correcttapelengthhasbeenselected,
FULL:Makesalloftheindicationsappearonthe
LCDmonitor/viewfinderduringplaybackor
recording.
SIMPLE:Makesthefollowingindications
disappearfromtheLCDmonitor/viewfinderduring
recordingorplayback:r'_, tape remaining time,
¢J-r_, tape length (__ pg. 9, 17).
Makes the date/time appear in the camcorder or on
a connected monitor (set DATE/TIME in SYSTEM
MENU first 6.. pg. 7).
• The selected display will be recorded. If you do
not want to record the display, select OFF before
shooting.
• In the AUTO DATE mode, the camcorder records
the date for about 5 seconds when recording is
initiated after the date is changed, a cassette is
loaded, or AUTO DATE is selected. The date is
replaced after 5 seconds with "AUTO DATE" but
this is not recorded.
You can record sequentially at preset time spans.
Leaving the camcorder aimed at a specific subject,
you can record subtle changes over an extended
period of time (Time-Lapse). REC MODE should
be set to "SP".
(Please note that it is necessary to set the REC
TIME (Animation) in the SYSTEM MENU before
performing the INT. TIME (Time-Lapse) function.)
Select the desired interval time and press the
Recording Start/Stop Button _).
• Fade- or wipe-in/out cannot be performed.
• This function is cancelled when the power is shut
off or when the cassette is ejected.
• To use this function, it is recommended that
SCROLL in TITLE SETUP (_ J pg. 18, 19) be set
to "OFF".
TEL_MA:CR_
When set to "ON", you can shoot a subject as large
as possible at a distance of approx. 60 cm (23-5t8").
Depending on the zoom position, the lens may go
out of focus.
ON: On-screen indications are displayed.
OFF: On-screen indications are turned off except
Date/Time, Instant Title and Warning Indication.
You can shoot a series of pictures, each slightly
different, of the same object for a brief selected
period of time (Animation). REC MODE should be
set to "SP".
Select the desired recording time and press the
Recording Start/Stop Button _) after focusing on
the subject.
• Fade- or wipe-in/out cannot be performed.
• This function is cancelled when the power is shut
off or when the cassette is ejected.
• To use this function, it is recommended that
SCROLL in TITLE SETUP (_., pg. 18, 19) be set
to "OFF".
To Next Page
Loading...
