Need help?Do you have a question about the JVC GR-SXM335U and is the answer not in the manual?
General| Type | Analog Camcorder |
|---|---|
| Optical Zoom | 16x |
| Digital Zoom | 700x |
| Image Sensor | CCD |
| Image Stabilizer | Electronic |
| Minimum Illumination | 2 lux |
| Microphone Operation Mode | Stereo |
| Display Type | LCD |
| Recording Format | VHS-C |
| Effective Pixels | 270, 000 pixels |
| Lens | Zoom Lens |
| Microphone | Built-in |
| LCD Screen Size | 2.5" |
| Video Resolution | 400 lines |
| Focus Adjustment | Automatic, manual |
| Shooting Modes | Auto, Manual |
| White Balance | Auto, Manual |
| Connector Type | S-Video |
| Viewfinder Type | Electronic |
| Viewfinder | Electronic |
| Dimensions | 4.3 in |
| Optical Sensor Size | 1/4 inch |
Detailed specifications for the camcorder's general, video, and audio functions.
Detailed breakdown of components within the final assembly of the camcorder.
List of electrical components for the main circuit board assembly.
Diagram showing how different circuit boards are interconnected within the camcorder.
Detailed schematic diagram of the Digital Signal Processing unit.
Detailed schematic diagram of the Digital Signal Processor unit.
Schematic diagram illustrating the iris, auto-focus, and zoom control circuitry.
Schematic diagram of the voltage regulator circuits within the camcorder.
Schematic diagram for the LCD control system, specific to the SXM735 model.
Diagram showing the physical layout of components on the main circuit board.
Important precautions to follow before disassembling the camcorder.
Step-by-step flowchart for disassembling cabinet parts.
Flowchart for disassembling camera and deck sections.
Steps for removing the CCD image sensor.
Steps for installing a new CCD image sensor.
Procedure for replacing the CCD board assembly.
List of error codes and their corresponding symptoms and modes.
Safety and handling precautions for mechanism adjustments.
Step-by-step procedure for disassembling and assembling mechanism parts.
Procedure to measure and adjust back tension.
Adjusting tape pattern and FM waveform for optimal playback.
Adjusting A/CTL head height and azimuth for signal levels.
Fine-tuning the phase of the A/C head for FM output.
Adjusting V COM to achieve sharp contrast on the LCD monitor.
Diagram showing the interconnection of various boards in the camcorder.
Detailed schematic of the Central Processing Unit and its connections.
Schematic diagram of the Video Tape Recorder - Advanced Signal Processor.
Schematic diagram for the mechanism's Motor Drive Amplifier.
Schematic diagram of the Video Tape Recorder - Digital Signal Processor.
Block diagram illustrating the camcorder's power distribution system.
Block diagram showing CPU and MDA system interactions.
Block diagram illustrating the camcorder's camera system.
Charts detailing voltage measurements for specific ICs.
To Next Page
