JVC GY-HM200U - Page 122

Clip Server
For setting the server and directory for uploading
recorded clips in the SD card to the FTP server.
9
Clip-FTP1 to Clip-FTP4
(The name specified in the respective
[Alias
] items is displayed)
o
Alias
For setting a name to distinguish the settings of
this camera recorder.
The
name set in this item will appear on the [FTP
Upload] action screen of the thumbnail display.
* Enter not more than 31 characters.
o
Protocol
For setting the protocol of the FTP server to be
connected.
0
FTP:
Protocol that does not encrypt the incoming
and outgoing data.
0
SFTP:
Protocol
that encrypts incoming and outgoing
data using SSH.
0
FTPS:
Protocol that encrypts incoming and outgoing
data using SSL or TLS. It uses an implicit
mode (starts encrypted communication once
connection starts).
0
FTPES:
Protocol that encrypts incoming and outgoing
data using SSL or TLS. It uses an explicit
mode (starts encrypted communication after
permission is granted).
[Setting Values: RFTP, SFTP, FTPS, FTPES]
o
Server
For setting the server name (“mystation.com”,
etc.)
or the IP address (“192.168.0.1”, etc.) of the
FTP server.
* Enter not more than 127 characters using
single-byte
alphanumeric characters (a to z, 0 to
9), single-byte hyphen [-], or dot [.].
o
Port
Enter the FTP server port number to use using
an integer between 1 and 65535.
The default value varies with the Protocol
setting.
(FTP: 21, SFTP: 22, FTPS: 990, FTPES: 21)
o
Dir. Path
Enter the path name for the directory to upload
to (“/pub
”, “/home/user”, etc.)
* Enter not more than 127 characters.
o
Username
Enter the user name for connecting to the FTP
server.
* Enter not more than 31 characters.
o
Password
Enter the password for connecting to the FTP
server.
* Enter not more than 31 characters.
o
PASV Mode
For setting whether to set the communication
mode
used for file transfer to the passive mode.
Set to “On” if the camera is inside a firewall, and
a connection from the FTP server to the camera
cannot be established.
[Setting Values: On, ROff]
Memo :
0
When [Protocol] is set to “SFTP
”, this item
appears as “---” and cannot be selected.
Reset Network
Restores all items in the
[Network] menu to their
default settings.
122
System Menu
Menu Display and Detailed Settings