14 EN
GETTING STARTED
MasterPage: Body_Left
This camera’s 2-way power supply system lets
you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging the Battery Pack
1 Set the power switch to OFF while pressing
down the lock button located on the switch.
2 Slide and hold OPEN in the direction of the
arrow a, then open the battery/CF card cover.
3 Insert the battery pack firmly into the battery
pack mount until it locks into space as shown in
the illustration.
4 Close the battery/CF card cover firmly until it
locks.
5 Connect the AC adapter to the camera.
6 Plug the AC adapter into an AC outlet. The
power/charge lamp on the camera blinks to
indicate charging has started.
7 When the power/charge lamp goes out,
charging is finished. Unplug the AC adapter from
the AC outlet. Disconnect the AC adapter from
the camera.
To detach the battery pack
Open the battery/CF card cover, and remove the
battery pack while sliding BATTERY in the
direction of the arrow b.
Required charging time
Power
To AC outlet
Power/Charge Lamp
Battery Pack
AC Adapter
Open the cover.
Power Switch
To DC connector
Lock Button
OPEN
Battery/CF Card
Cover
Protrusion
mark
Battery pack Charging time
BN-VM200U (provided) Approx. 1 hr. 35 min.
BATTERY
GZ-MC500US.book Page 14 Wednesday, April 13, 2005 7:08 PM
To Next Page
Loading...
