Troubleshooting (Continued)
• Slide the mode switch to select the desired mode
(til
or
Q).
• If the camcorder temperature increases, REC flashes
in
the LCD
monitor and recording stops automatically to protect the
HOD.
Turn off the camcorder, wait for a while, and start recording again.
• Move away from a place where the camcorder is affected by
excessive sound or vibration (such as a concert hall).
• A malfunction may occur
in
the HOD of the camcorder.
In
this
case, record to a microSD card.
• Insert a commercially available microSD card, and set each of the
[REC MEDIA FOR VIDEO] and [REC MEDIA FOR IMAGE] to
[SO].
• Recording stops automatically after 12 hours of continuous
recording.
• Sometimes playback is interrupted at the connecting section
between two scenes. This is not a malfunction.
• Select [PLAYBACK MPG FILE] then search the video
on
the index
screen.
(Video files that have damaged management information can be
played back.)
• Cancel group display and date search functions.
• Change the setting
in
[REC MEDIA FOR VIDEO] or [REC MEDIA
FOR IMAGE]. (Files on other media are not displayed.)
• Check the remaining battery pack charge.
(When the battery pack is fully charged, the lamp does not flash.)
• When recharging
in
either a hot or cold environment, ensure that
battery
is
being charged within the permitted temperature range.
(If the battery pack
is
being recharged outside the permitted
temperature range, recharging may stop to protect the battery pack.)
•
When
connecting
to
the
HDMI
cable, the image
or
sound
may
not
appear
on the
TV
properly
depending on the
TV
connected. In
such
cases, perform the following operations.
1) Disconnect
the
HDMI
cable
and
connect it again.
2) Turn off and on the
camcorder
again.
• TVs may operate differently depending
on
the specifications,
even if they are HDMI-CEC compliant. Therefore, the HDMI-CEC
functions of the camcorder cannot be guaranteed to operate
in
combination with all the
TVs.ln
such cases, set [HDMI CONTROL]
to [OFF].
• If a malfunction
occurs
in the
HOD
CD
Perform
[FORMAT
HOD]. (All
data
is deleted.)
® If
this
does
not
solve the problem, perform the disc
check
function from a PC after formatting.
® If this
does
not
solve the problem, contact the
JVC
customer
service for repairs.
•
To
reset the camcorder when
it
does
not
operate normally
CD
Close the
LCD
monitor
and remove the
power
supply
(battery
pack
or
AC adapter) from the
camcorder, then reattach it.
® Execute [FACTORY PRESET].
38
EN
To Next Page
Loading...
Need help?
General