To Next Page

To Previous Page

(No.YF139)1-17

SECTION 5

TROUBLE SHOOTING

5.1 SERVICE NOTE

[20]

3-2-4

[14]

3-2-3

[1] [2] [3] [4] [5] [6] [7] [8] [9]

1 2 3 4 5 - 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

CA1 FA1 FA2

aeae

FA4

FA3 FA5

UA1

aad c

[10] [11] [12] [13] [14] [15] [16] [17]

23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

FA6 UA2 UA3 UA4 UA5 FA7

aaabe

[18] [19] [20]

47 48 49 50 51 52 53 54 55

1 2 3 4 5 6 7

1 2 3 4 5 6 7 8 9 10 11 12 13

FA8 FA9 FA10

Symbol No.

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

Symbol No.

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

Symbol No.

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

Symbol No.

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

CABINET PARTS AND ELECTRICAL PARTS(1)

CABINET PARTS AND ELECTRICAL PARTS(3)

[14]MONITOR ASSY

CABINET PARTS AND ELECTRICAL PARTS(2)

[20]OP BLOCK ASSY/CCD BOARD ASSY

NOTE:

1 ) and (This mark shows where to attach the screws) : Do not reuse the screws because the screw lock bond was applied to prevent the screws from loosening.

Prepare the specified screws and use them in place of the removed screws.

2 )Tightening torque for the screws

There are setting limits of the torque value for the torque driver. If the value exceeds the setting value, take it as a rough measurement (reference value),

and tighten the screw manually.

The specified torque value is a recommended value of the initial assembly. Therefore, set the value below the specified torque value in the assembling procedure.

Be careful not to break either the screws or the screw holes.

a : 0.098N m (1.0kgf cm) b : 0.248N m (2.5kgf cm) c : 0.118N m (1.2kgf cm) d : 0.147N m (1.5kgf cm) e : 0.078N m (0.8kgf cm)