JVC HR-XVS20EK - Page 73

Masterpage:Right-No-Heading
73
Filename [XVS20EK_10Subsidiary.fm]
Page 73 March 28, 2003 6:57 pm
* The default setting is
bold
in the table below.
8
POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the power consumption
while the unit is turned off.
NOTES:
●
During Power Save mode:
— the front display panel will be turned off.
— the Just Clock function (
墌
pg. 86) does not work.
— the picture may be distorted momentarily when you turn on/off the unit.
●
Power Save does not work when:
— the unit is in the Timer mode.
— the unit’s power is turned off after timer-recording or Instant Timer Recording.
— the Automatic Satellite Programme Recording mode is engaged. (
墌
pg. 37)
— “L-2 SELECT” is set to “DECODER” or “SAT”. (
墌
pg. 63)
8
VIDEO STABILIZER
ON
OFF
When this function is set to “ON”, you can automatically correct vertical
vibration in the picture when playing back unstable recordings made on
another recorder.
NOTES:
●
When you finish viewing a tape, be sure to set this function to “OFF”.
●
Regardless of the setting, this function has no effect during recording and during
special effects playback.
●
The on-screen display may jitter vertically when this function is set to “ON”.
●
To watch recordings with close-caption, set this function to “OFF”.
8
S-VHS
ON
OFF
Your unit can record in S-VHS (Super VHS), S-VHS ET or VHS.
●
To record in S-VHS:
Set “S-VHS” to “ON”. Then, insert a cassette marked “S-VHS”. The S-VHS
indicator lights up on the front display panel.
The S-VHS recording mode is selected.
●
To record in S-VHS ET on a VHS cassette:
Set “S-VHS ET” to “ON”. (
墌
pg. 71) Then, insert a cassette marked “VHS”.
The S-VHS indicator lights up on the front display panel.
●
To record in VHS:
Insert a cassette marked “VHS”.
Set “S-VHS ET” to “OFF”. (
墌
pg. 71)
The VHS recording mode is automatically selected regardless of the “S-VHS”
mode setting.
●
To record in VHS on an S-VHS cassette:
Insert a cassette marked “S-VHS”. The S-VHS indicator lights up on the front
display panel. Then, set “S-VHS” to “OFF”. The S-VHS indicator goes off.
The VHS recording mode is selected.
NOTE:
When playing back a tape that has been recorded in S-VHS or S-VHS ET, the S-VHS
indicator lights up on the front display panel regardless of the “S-VHS” mode setting.
8
AUTO POWER OFF
3H
OFF
When this function is set to “3H”, the unit is turned off automatically if no
operation is done within 3 hours. “AUTO POWER OFF IN 3 MIN” appears
on the screen 3 minutes before the unit is turned off.
XVS20EK_01.book Page 73 Friday, March 28, 2003 7:00 PM