ConnectingOtherEquipment
You can connect an external audio component used only as a
playback device.
• DO NOT connect any equipment while the power [
is on.
I
• DO NOT plug in any equipment until all connections
are complete.
Toconnectan externalaudiocomponent
Be sure that the plugs of the audio cords are colored: White
plugs and jacks are for left audio signals, and red ones for
right audio signals.
To play external audio component through this unit,
connect between the audio outputjacks on the other
equipment and AUX jacks by using an audio cord (not
supplied).
Cancelingthe Demonstration
When connecting the AC power cord to a wall outlet, the unit
automatically starts demonstration.
To cancel the demonstration, press and hold CANCEL
CANCEL/DEMO until "DEMO OFP" appears /DEMO
on the display.
• To cancel only beep sounds during the .......
demonslration, press and hold BEEP for more
than 2 seconds or press BEEP ON/OFF on the
_mote control.
The BEEP ON indicator goes off from the
display.
_When yon press other buttons
The demonstration stops temporarily, It will start automalically
again (if no operation is done for 2 minutes) unless you cancel it by
pressing CANCEL/DEMO.
To audio output
Audio equipment
Tostartdemonstrationmanually
Press and hoM CANCEL/DEMO again until "DEMO START"
appears on the display.
Now, you can plug the AC power cord.
I MPORTANT: Be sure to check that all connections are I
done before plugging the AC power cord into a wall outlet.
I
8
To Next Page
Loading...
