UsingRecordingTimer
With Recording Timer, you can make a tape of a radio
broadcast automatically.
HowRecordingTimer actuallyworks
The unit automatically turns on, tunes in to the specified
station, sets lhe volume level to "VOLUME MIN," and starts
l_cording when lhe on-time comes. ("REC" and the REC
indicator on the display flash just befo_ the on-time. The
REC indicator continues flashing while the timer is
operating). Then, when the off-time comes ("REC OFF"
appears on lhe display just before the off-time), the unit
automatically turns off (standby).
The timer setting remains in memory until you change it.
• There is a time limit in doing lhe following steps. If the selting
is canceled before you finish, start from step 2 again.
• To correct a mistake while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1 Insert a recordable cassette with the exposed
part of the tape down.
2 Press _) CLOCK/[IMER repeatedly G
until "REC" appears on the display. CLOCK
/TIMER
The @ (Timer) indicator lights up and lhe REC
(Recording Timer) indicator also starts flashing
on the display.
pE r
I._
• Each time you press the button, the timer setting modes
change as follows:
oA,L -- T,MER
Canceled _- Clock -'-- TIME
setting (Recording Timer set, rig)
(The hour digits starl flashing)
3Press _ CLOCK/[IMER again.
"TIMER" appears for about 2 seconds, then CLOCK
/TIMER
the unit enters on-time setting mode.
n i_i
l._l Iq
4 Set the on4ime you want the unit to turn on
at.
1) Turn _ / _ to set the horn;
then press SET/DISPLAY.
2) Turn _ / _ to set the minute,
then press SET/DISPLAY.
"SET" appears for about 1
second, then the unit enters off-
time setting mode.
SET
/DISPLAY
ncc
Ul I
i!!!i__iii__
n h,, l
,-,,, ,
5 Set the off-time you want the unit to turn off
(standby) at.
1) Turn _ / _ to set the horn; then p_ss
SET/DISPLAY.
2) Turn _ / _ to set the minute, then press
SET/DISPLAY.
"SET" appears for about 1 second, then the unit enters
p_set station selecting mode.
6 Select the preset station.
1) Turn _ / _ to select the band ("TUNER FM" or
'_FUNERAM"), then pl_ss SET/DISPLAY.
"SET" appears for about 1second.
2) Turn _ / _ to select a pz_set channel number,
then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
and l_mains lit. "OK J" appe_s on the display for
about 2 seconds.
The settings you have done are shown on the display
in sequence for your confirmation.
7 Press O/Ito turn off the unit _- Oil-
(standby) if necessary. ° ° °
• If yon want to listen to another source while recording
Press REC START/STOP or • to stop recording. Without
stopping it, you cannot change the source.
• Even if you unplug the AC power cord or if a power failure
oeenrs
Once you set the timer, the timer setting may remain slored in
memory for a few days. Check whether or not the timer setting
still remains.
25
To Next Page
Loading...
