ENGLISH
11OPERATIONS
Continued on the next page
3 Select “Memory.”
4 Select a preset number (“Preset1”–
“Preset6”) you want to store into.
5 Select one of the PTY codes.
6 Store the selected PTY code.
7 Repeat steps 4 to 6 to store other PTY codes
into other preset numbers.
8 Exit from the setting.
Activating TA/PTY Standby
Reception
TA Standby Reception
1
2
either lights up or flashes on the display.
• If lights up, the unit temporarily will switch
to Traffic Announcement (TA), if available, from
any source other than AM.
The volume changes to the preset TA volume
level if the current level is lower than the preset
level (see page 34).
• If
flashes, TA Standby reception is not yet
activated. Tune in to another station providing
the RDS signals.
To deactivate TA Standby Reception, select “Off” in
step 2.
goes off.
PTY Standby Reception
1
2
3
Select a PTY code.
Ex.: When “Classics” is selected in step 5
EN08-15_KD-BT22[E]_003A_f.indd 11EN08-15_KD-BT22[E]_003A_f.indd 11 1/25/08 9:54:38 AM1/25/08 9:54:38 AM
To Next Page
Loading...
Need help?
General
