JVC KD-ADV38

OPERATIONS
37
ENGLISH
Using the Bluetooth audio player
*
1
Each time you press 5 ∞, the registered device
names (and “NEW DEVICE” when a new device can
be registered) appear in turn. You cannot select “New
Device” when a Bluetooth audio player is connected.
*
2
Appears only when the information comes from the
device.
*
3
Indicates the button pressed. It may be different from
the operation status.
*
4
When a cellular phone with audio function is
connected, appears.
You can use the following buttons on the remote
controller for the Bluetooth audio operations. For
details, ☞ pages 8 and 9.
3: 45PM
FLAT
Connected device name
Bluetooth Audio
POWER]ON
Pause
Reverse/forward skip
*
1
Status of the device*
2
Signal strength/Battery remainder
☞ page 46
List menu icon
AV Menu
Setup
Enter
ENT
AV Menu
List
Enter
ENT
*
3
~ Select “Bluetooth Audio.”
Ÿ Start playback.
• See pages 31 to 33 for connecting a new device.
• See page 33 for connecting/disconnecting a
registered device.
• See page 33 for deleting a registered device.
When the sound is stopped or interrupted during
the use of a Bluetooth device, try the following
remedies.
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the
device again. (☞ “Connecting/disconnecting a
registered device” on page 33)
• Preset List can also be accessed through <AV
Menu> = <List>.
You can use the following buttons on the remote
controller for the Bluetooth phone operations. For
details, ☞ pages 8 and 9.
Turns Blue when the Bluetooth
device is connected.
*
4
Bluetooth Information:
If you wish to receive more information about
Bluetooth, visit our JVC web site.
AVX33_J 37AVX33_J 37 07.2.1 2:48:49 PM07.2.1 2:48:49 PM