E
Connecting the external amplifiers and/or subwoofer
/
ોો؟ʩወ֝ƅචࡍљࡗಚᑶወ
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment
so that it can be controlled through this unit.
• For amplifier only:
– Disconnect the speakers from this unit, connect them to the amplifier. Leave the
speaker leads of this unit unused.
– For KD-DV6206/KD-DV6205: The line output level of this unit is kept high to maintain the
hi-fi sounds reproduced from this unit.
When connecting an external amplifier to this unit, turn down the gain control on the
external amplifier to obtain the best performance from this unit.
Only for KD-DV6206/KD-DV6205
ࡎ KD-DV6206/KD-DV6205
To the remote lead of other equipment or auto antenna if any
вմ༫ʕڄჲለб˭ለࠜЉ༫
Y-connector (not supplied for this unit)
Y-ܓለʿᎲʹጅಏա
Remote lead
ჲለ
*
5
Signal cord (not supplied for this unit)
*
5
ۑ༙ྐងʿᎲʹጅಏա
Front speakers
ۮಙᑵ
Rear speakers
݈ಙᑵ
JVC Amplifier
JVC ୋ؟ʩወ
JVC Amplifier
JVC ୋ؟ʩወ
Subwoofer
ඟࡌјࡖಙᑵ
Front speakers
ۮಙᑵ
Remote lead (Blue with white stripe)
ჲለᕇиઘЉΎиঙ
*
6
Firmly attach the ground wire to the metallic body or to the chassis of the
car—to the place uncoated with paint (if coated with paint, remove the paint
before attaching the wire). Failure to do so may cause damage to the unit.
*
6
અϙለႩہᚙԾᝂږԆԾנᇟႌંçளᏻ༳ԅЉூٛွᕒႵϨس
ʵดʕٛွçϚྐለۮçઅٛွսéϨسʿᆟç๑ᖢʹጅé
F
Connecting the external components / ોյોஈέ
Other external component / յોஈέ
Only for KD-DV5206/KD-DV5205 / ࡎ KD-DV5206/KD-DV5205
• Set “EXT IN” for the external input setting (See page 36 of the INSTRUCTIONS.)
/
આ௱᎕ʉׇг“EXT IN” (௱᎕ʉ) (ኍՠΈკبڅ୷36ࡘê)
*
10
Line Input Adapter KS-U57 (not supplied for this unit)
*
10
ྐཔ᎔ʈቱKS-U57 ʿᎲʹጅಏա
External component
ોஈέ
Only for KD-DV6206/KD-DV6205
ࡎ KD-DV6206/KD-DV6205
6
؞ʨ˥ঠڄԆԾΘᝂᑵԦé
• અჲለᕇиઘЉΎиঙ֜մ༫ʕڄჲለ৹գç۔ཫʹጅනм
ჲé
• ෯բୋ؟ʩወЪʶ!
üઆಚᑶወ֝͵ጆᔄෆèκોʖୋ؟ʩወêઆ͵ጆڅಚᑶወોሉ؟ˀΈê
üࡎKD-DV6206/KD-DV6205 ʹጅڄ᎔ၷʪۘݠܾۘ෭ࡖᛏس
ιЎ୕Άé
ະ௰؞ʨвʹጅçቁᕢј௰؞ʨڄϯ࠳վ۔ᐺ֊ʹጅചಓ
ڄఛ՞سé
JVC Amplifier
JVC ୋ؟ʩወ
CD changer, Apple iPod
®
, or JVC D. player / CDಘၫወéApple iPod
®
JVC D. player
You can connect these components as illustrated below. The iPod
*
7
or D. player can be
connected using an interface adapter (not supplied)—KS-PD100 (for iPod) or KS-PD500 (for
D. player).
• Set “CHANGER” for the external input setting (See page 36 of the INSTRUCTIONS.)
/
આ௱᎕ʉׇг“CHANGER” (ಘၫወ) (ኍՠΈკبڅ୷ 36 ࡘê)
અஇάϨ࿌Εනмé՟·ߍࡒቱʿక—KS-PD100 (iPod·
KS-PD500 D. player·iPod
*
7
D. playeré
Apple iPod
(separately purchased)
Apple iPod
ᒯ
JVC D. player
(separately purchased)
JVC D. player
ᒯ
JVC CD changer
JVC CD ಘၫወ
or
CAUTION / ʯ˼î
• Before connecting the external components, make sure that the unit is turned off.
• இά˃ۮçζᇧ׆ʹጅʵᘕé
*
8
Connecting cord supplied for your CD changer
*
8
ڄCD ಗၪకڄྐង
*
7
iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
*
7
iPod ݵApple Computer, Inc.ăᙧسྐ༃˙ĄϚࠀ˪մࣁٌڄᆤé
CD changer jack
CDಗၪࣙ
CD changer jack
CDಗၪࣙ
External component
ોஈέ
*
9
Signal cord (not supplied for this unit)
*
9
ۑ༙ྐងʿᎲʹጅಏա
Instal4-6_DV6206_005A_1.indd 6Instal4-6_DV6206_005A_1.indd 6 2/27/06 4:15:49 PM2/27/06 4:15:49 PM