12
ENGLISH
General settings — PSM
You can change PSM (Preferred Setting Mode)
items listed in the table that follows.
1
2 Select a PSM item.
3 Adjust the PSM item selected.
4 Repeat steps 2 and 3 to adjust other
PSM items if necessary.
5 Finish the procedure.
2
Indication [Range]
BAS*
1
(bass)
Adjust the bass. [–06 to +06]
TRE*
1
(treble)
Adjust the treble. [–06 to +06]
FAD*
2
(fader)
Adjust the front and rear speaker balance.
[R06 to F06]
BAL*
3
(balance)
Adjust the left and right speaker balance.
[L06 to R06]
LOUD*
1
(loudness)
Boost low and high frequencies to produce
a well-balanced sound at low volume level.
[LOUD ON or LOUD OFF]
SUB.W*
4
(subwoofer)
Adjust the subwoofer output level. [00 to 08]
VOL (volume)
Adjust the volume. [00 to 30 or 50*
5
]
*
1
When you adjust the bass, treble, or loudness,
the adjustment you have made is stored for
the currently selected sound mode (C-EQ)
including “USER.”
*
2
If you are using a two-speaker system, set the
fader level to “00.”
*
3
This adjustment cannot affect the subwoofer
output.
*
4
This takes effect only when a subwoofer is
connected.
Displayed only when “L/O MODE” is set to
“WOOFER” (see page 13).
*
5
Depending on the amplifier gain control
setting. (See page 13 for details.)
Ex.: When “DIMMER” is selected
EN12-17_KD-G425[U_UH]f.indd 12EN12-17_KD-G425[U_UH]f.indd 12 11/23/05 12:10:09 PM11/23/05 12:10:09 PM
To Next Page
Loading...
