EasyManuals Logo

JVC KD-R460J User Manual

JVC KD-R460J
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
(No.MA596<Rev.005>)26/28
4.7.2 ERROR CODE for MODEL with FLM-HCI MECHA (Ver1.1)
4.8 Tuner Span Change Mode
Pressing and holding [VOL] key, press [RETURN] key for 3 seconds.
4.8.1 Default status immediately after the mode activation
It shall be same as normal activation.
After selection of the setting item, the receiver should exit this mode and return to the display before entering this mode.
This setting will be stored in EEPROM.
4.8.2 Mode content
Syscon shall display the following information after entering this mode.
*1: Only applicable for Asia ('U') models
*2: Only applicable for Europe ('E') models
DISPLAY SIGN ERROR Item Condition Details
LI-E LOADING TIME OVER
In LOAD operating. Anomaly detection of SW state at LOADING.
Or 5 sec TIME OVER from LOAD start.
EJ-E EJECT TIME OVER
In EJECT operating. Anomaly detection of SW state at EJECT.
Or 5 sec TIME OVER from EJECT start.
E-04 READ ERROR In RUNNING MODE operating TOC read error.
E-14 FOCUS ERROR In RUNNING MODE operating Focus Error. No complete Focus ON.
E-05 UNKNOWN DISC In RUNNING MODE operating No reflection.
E-20 NODISC ERROR In RUNNING MODE operating In case of DISC distinction.
E-21 DSP ACCESS ERROR In RUNNING MODE operating fails in the access to DSP.
E-22 LIM SW ERROR In RUNNING MODE operating Time over in case of that moves to an inner side.
AE-01
AUTO ADJUSTMENT
ERROR
In RUNNING MODE operating Focus Gain Error
AE-02 In RUNNING MODE operating Tracking Gain Error
AE-03 In RUNNING MODE operating RF Gain Error
AE-04 In RUNNING MODE operating Tracking Balance Error
AE-05 In RUNNING MODE operating Focus Balance Error
AE-06 In RUNNING MODE operating Focus Offset Error
AE-07 In RUNNING MODE operating Tracking Offset Error
AE-08 In RUNNING MODE operating RF Offset Error
Item Operation Display content Details
Tuner Span
Change Mode
(*1)
VOL +/-
Default setting for Asia models.
Change to 'Asia' area type.
Change to 'Tunisia' area type.
Tuner Span
Change Mode
(*2)
VOL +/-
Default setting for Europe models.
Change to 'Europe' area type.
Change to 'Tunisia' area type.
Release Mode VOL
Depending on display pattern in normal mode.
ARE A AS I A
AREA TUNISIA
AREA EUROPE
AREA TUNISIA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC KD-R460J and is the answer not in the manual?

JVC KD-R460J Specifications

General IconGeneral
BrandJVC
ModelKD-R460J
CategoryCar Receiver
LanguageEnglish

Related product manuals