(No.MA596<Rev.005>)17/28
SECTION 4
ADJUSTMENT
4.1 Outline
4.1.1 Panel
A symbol "" in the key column indicates that the key should be pressed and held for 1 second or longer.
4.1.2 Test Modes
These test modes are available in normal production ROM.
Transition to Test Mode shall be available during DC Error detection.
4.1.3 Release from Test Mode
These actions will release the Test Mode and transit back to Normal Mode
RETURN
ACCENT SEARCHVOL
Test Mode Mode Source Operation
Production Test Mode - All Press and hold [DISP] key and [SOURCE] key and reset.
Service Test Mode Normal Mode /
Production Mode
All Pressing and holding [DISP] key, press [] key for 7 seconds.
(Starting to press [DISP] key and [] key at the same time can not
be entered into the mode)
Service Information Clear Mode - All Press and hold [RETURN] key and [SOURCE] key and reset.
DC Error Information Mode - All Press and hold [DISP] key and [] key and reset.
DOP Test Mode Normal Mode All Pressing and holding [SELECT] key, press [DISP] key for 7 sec-
onds.
(Starting to press [SELECT] key and [DISP] key at the same time
can not be entered into the mode)
HC Mecha Running Mode - All Press and hold [SOURCE] key and [EJECT] key and reset.
Tunisia Area /
Tuner Span Change Mode
Normal Mode All Pressing and holding [VOL] key, press [RETURN] key for 3 sec-
onds.
Method Remarks
Reset All Modes
Momentarily voltage drop All Modes
ACC OFF All Modes
POWER OFF All Modes
Panel Detach All Modes
To Next Page
Loading...
Need help?
General
