18
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
TROUBLESHOOTING
Symptom Remedy
“CANNOT PLAY” flashes and/
or connected device cannot
be detected.
• Check whether the connected device is compatible with this
unit and ensure the files are in supported formats.
( 16)
• Reattach the device.
“READING” keeps flashing. • Do not use too many hierarchical levels and folders.
• Reload the disc or reattach the USB device.
The iPod/iPhone does not
turn on or does not work.
• Check the connection between this unit and iPod/iPhone.
• Detach and reset the iPod/iPhone using hard reset.
Bluetooth®
No Bluetooth device
is detected.
• Search from the Bluetooth device again.
• Reset the unit.
( 3)
Pairing cannot be
made.
• Make sure you have entered the same PIN code to both the
unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again.
( 9)
“PAIRING FULL”
appears.
The number of registered devices has reached its limit. Retry
after deleting an unnecessary device.
( 12, DELETE PAIR)
“PLEASE WAIT”
appears.
The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
“BT DEVICE NOT
FOUND” appears.
The unit failed to search for the registered Bluetooth devices
during
[AUTO CNNCT]
. Turn on Bluetooth from your device
and connect manually.
( 13)
Echo or noise occurs. • Adjust the microphone unit’s position.
( 9)
• Check the
[ECHO CANCEL]
setting.
( 10)
Phone sound quality
is poor.
• Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
Symptom Remedy
Bluetooth®
“NOT SUPPORT” appears. The connected phone does not support Voice
Recognition feature.
“ERROR” appears. Try the operation again. If “ERROR” appears again,
check if the device supports the function you have
tried.
The unit does not respond
when you try to copy the
phonebook to the unit.
You may have tried to copy the same entries (as
stored) to the unit. Press
DISP
or
GT/P
to exit.
Sound is being interrupted or
skipped during playback of a
Bluetooth audio player.
• Reduce the distance between the unit and the
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect
again.
• Other Bluetooth devices might be trying to connect
to the unit.
The connected Bluetooth
audio player cannot be
controlled.
• Check whether the connected Bluetooth audio
player supports Audio/Video Remote Control Profile
(AVRCP). (Refer to the instructions of your audio
player.)
• Disconnect and connect the Bluetooth player again.
“H/W ERROR” appears. Reset the unit and try the operation again. If “H/W
ERROR” appears again, consult your nearest service
center.
“BT ERROR PLS UPDATE”
appears.
Update the Bluetooth firmware.
( 4)
If you still have troubles, reset the unit. ( 3)
JS_JVC_KD_R951BT_E_02_EN.indd 18JS_JVC_KD_R951BT_E_02_EN.indd 18 12/9/2013 4:11:40 PM12/9/2013 4:11:40 PM
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
Weight and Dimensions
