ENGLISH
4
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
Cancel the demonstration
When you turn on the power for the first time (or
[FACTORY RESET]
is set to
[YES]
), the display shows: “CANCEL DEMO” “PRESS ENTER”
1 Press .
[YES]
is selected for the initial setup.
2 Press again.
“DEMO OFF” appears.
Set the clock and date
1
Press and hold .
2 Press to select
[CLOCK]
, then press .
To adjust the clock
3 Press to select
[CLOCK ADJUST]
, then press .
4 Press to make the settings, then press .
Hour
Minute
5 Press to select
[CLOCK FORMAT]
, then press .
6 Press to select
[12H]
or
[24H]
, then press .
To set the date
7 Press to select
[DATE SET]
, then press .
8 Press to make the settings, then press .
Day
Month Year
9 Press to exit.
To return to the previous setting item, press .
1
2
Set the basic settings
1
Press and hold .
2 Press to select an item (see the following table), then
press
.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press .
Default:
XX
SYSTEM
KEY BEEP
(Not applicable when 3-way crossover is selected.)
ON
:Activates the keypress tone.;
OFF
:Deactivates.
SOURCE SELECT
AM SRC
*
ON
:Enables AM in source selection.;
OFF
:Disables.
( 5)
PANDORA SRC
*
ON
:Enables PANDORA FRONT/PANDORA REAR/PANDORA in source
selection.;
OFF
:Disables.
( 9)
IHEART SRC
*
ON
:Enables IHEART FRONT/IHEART REAR/IHEARTRADIO in source
selection.;
OFF
:Disables.
( 10)
BUILT-IN AUX
*
ON
:Enables AUX in source selection.;
OFF
:Disables.
( 21)
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx
YES
:Starts upgrading the firmware.;
NO
:Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
FACTORY RESET YES
:Resets the settings to default (except the stored station).;
NO
:Cancels.
*
Not displayed when the corresponding source is selected.
3
JS_JVC_KD_R988BTS_K_EN_5.indd 4JS_JVC_KD_R988BTS_K_EN_5.indd 4 9/1/2016 11:03:54 AM9/1/2016 11:03:54 AM
To Next Page
Loading...
