JVC KD-S12 - General settings - PSM; Basic procedure

13
ENGLISH
Indications Selectable settings, [reference page]
DEMO
Display demonstration
DEMO ON : [Initial]; Display demonstration will be activated
automatically if no operation is done for about
20 seconds, [7].
DEMO OFF : Cancels.
CLOCK H
Hour adjustment
1 – 12, [7]
[Initial: 1 (1:00)]
CLOCK M
Minute adjustment
00 – 59, [7]
[Initial: 00 (1:00)]
AMP GAIN
Amplifier gain control
You can change the maximum volume level of this unit.
LOW PWR : VOL 00 – VOL 30 (Select this if the maximum
power of the speaker is less than 50 W to avoid
damaging the speaker.)
HIGH PWR : [Initial]; VOL 00 – VOL 50
AREA
Tuner channel interval
AREA EU : Select this when using the unit in an area other than
North and South America. (FM: 50 kHz—manual
tuning, 100 kHz—auto search; AM: 9 kHz)
AREA US : [Initial]; Select this when using the unit in North or
South America. (FM: 200 kHz; AM: 10 kHz)
General settings — PSM
Basic procedure
You can change PSM (Preferred Setting Mode)
items listed on the table that follows.
1
2
Select a PSM item.
Ex.: When you select “AMP GAIN”
3 Adjust the PSM item selected.
4 Repeat steps 2 and 3 to adjust the
other PSM items if necessary.
5 Finish the procedure.
EN10-13_KD-S12[J]f.indd 13EN10-13_KD-S12[J]f.indd 13 7/11/05 4:02:32 PM7/11/05 4:02:32 PM