ENGLISH
13
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
To On the faceplate
While having two active calls...
End current call and activate
held call
Press and hold
or the volume
knob.
Swap between the current
call and held call
Press
.
Adjust the phone volume
*
1
[00]
to
[35]
(Default:
[15]
)
Turn the volume knob during a call.
Switch between hands-free
and private talk modes
*
2
Press during a call.
*
1
This adjustment will not affect the volume of the other sources.
*
2
Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone....
1 Press and hold .
2 Turn the volume knob to select an item
(
see the following table
)
,
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
.
Default:
XX
MIC GAIN LEVEL –10
to
LEVEL +10
(
LEVEL –04
):The sensitivity of the microphone
increases as the number increased.
NR LEVEL LEVEL –05
to
LEVEL+05
(
LEVEL 00
):Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
ECHO CANCEL LEVEL –05
to
LEVEL +05
(
LEVEL 00
):Adjust the echo cancellation delay
time until the least echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
To return to the previous setting item, press
.
Default:
XX
SETTINGS
AUTO ANSWER
01 SEC
to
30 SEC
:The unit answers incoming call automatically in the
selected time (in seconds).;
OFF
:Cancels.
RING ILLUMI BLINK 01
to
BLINK 05
(
BLINK 02
): Selects the blinking pattern for the
buttons as notification when there is an incoming call.;
OFF
:Cancels.
Make a call
You can make a call from the call history, phonebook, or dialing the
number. Call by voice is also possible if your mobile phone has the
feature.
1 Press to enter Bluetooth mode.
“(First device name)” appears.
• If two Bluetooth phones are connected, press again to switch
to another phone.
“(Second device name)” appears.
2 Turn the volume knob to select an item
( 14)
, then press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow
the instructions stated on the selected item.
To return to the previous setting item, press
.
BLUETOOTH®
JS_JVC_KD_SX24BT_K_EN_1.indd 13JS_JVC_KD_SX24BT_K_EN_1.indd 13 20/6/2017 11:22:55 AM20/6/2017 11:22:55 AM
To Next Page
Loading...
Need help?
General
