ENGLISH
32
To change the display information while
tuning into an ensemble
Normally service name is shown on the display.
If you want to change the display information,
press DISP.
Each time you press the button, the following
information appears on the display for a while.
To tune into a particular ensemble without
searching:
1 Press and hold DAB (FM AM) to select DAB
tuner as the source.
2 Press DAB (FM AM) repeatedly to select the
DAB band (DAB1, DAB2 or DAB3).
3 Press and hold ¢ or 4 for more
than 1 second.
4 Press ¢ or 4 repeatedly until the
ensemble you want is reached.
• If you hold down the button, the frequency
keeps changing until you release the button.
To restore the FM/AM tuner
Press and hold DAB (FM AM) again.
Ensemble name
Service name
Channel number
Frequency
Press ¢ to search
ensembles of higher
frequencies.
Press 4 to search
ensembles of lower
frequencies.
3
Start searching an ensemble.
When an ensemble is received, searching
stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
4
Select a service you want to listen to.
MO
Press 5 (RND MO) to select
the next service.
Press ∞ (RPT) to select the
previous service.
EN30-34.KD-SX991R&911R[E]f 12/18/00, 3:49 PM32
To Next Page
Loading...
Need help?
General
