JVC KD-X176 - Configure Basic Settings

ENGLISH
5
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
9 Press to exit.
To return to the previous setting item, press
.
Set the basic settings
1
Press and hold .
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
.
Default: [XX]
[SYSTEM]
[KEY BEEP]
[ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]*
[ON]: Enables AM in source selection. ; [OFF]: Disables. (Page 6)
[BUILT-IN AUX]*
[ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 9)
[F/W UPDATE]
[UPDATE SYSTEM]
[F/W UP xxxx]
[YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<http://www.jvc.net/cs/car/>.
3
[CLOCK]
[TIME SYNC]
[ON]: The clock time is automatically set using the Clock Time (CT) data in
FM Radio Data System signal. ; [OFF]: Cancels.
[CLOCK DISPLAY]
[ON]: The clock time is shown on the display even when the unit is turned
off. ; [OFF]: Cancels.
[ENGLISH]
Select the display language for menu and music information if applicable.
By default, [ENGLISH] is selected.
[РУССКИЙ]
[ESPANOL]
[FRANCAIS]
[DEMOMODE]
[ON]: Activates the display demonstration automatically if no operation is
done for about 15 seconds. ; [OFF]: Deactivates.
* Not displayed when the corresponding source is selected.
Getting Started
JS_JVC_KD_X176_E_EN_int1.indd 5JS_JVC_KD_X176_E_EN_int1.indd 5 4/22/2019 10:14:31 AM4/22/2019 10:14:31 AM