To Next PageTo Next PageWhat to do if JVC KD-X120EE Receiver shows DC offset error?
If your JVC Receiver displays a DC offset error, ensure the speaker lead terminals are properly covered with insulating tape. Then, reset the receiver. If the error persists after resetting, it indicates an issue requiring internal repair.
General| Power Output | 50W x 4 |
|---|---|
| RMS Power Output | 22W x 4 |
| Tuner | FM/AM |
| Bluetooth | Yes |
| USB Input | Yes |
| Display Type | LCD |
| Subwoofer Output | Yes |
| AUX Input | Yes |
| RDS | Yes |
| Detachable Faceplate | No |
| Remote Control | Yes |
| Steering Wheel Control | Yes |
| Audio Formats Supported | MP3, WMA |
| EQ Settings | 13-Band Graphic EQ |
Guidelines on design changes, replacement parts, and proper lead routing for safety.
Covers meeting safety standards, legal responsibilities, and handling of burrs.
Identifies critical safety parts and explains ESD prevention measures like grounding.
Procedure for repairing a blown fuse pattern, including checks before reassembly.
Steps for disassembling the main body, including removing the front chassis and main PWB.
Provides an overview of the panel, lists available test modes, and explains how to exit them.
Details the DC offset detection circuit design, possible causes, and checking methods.
Covers detection timing, manipulation after error, and methods to cancel/clear DC offset errors.
Advises on discrepancies in schematic part numbers and critical safety parts in the list.
Covers handling of GNDs, power cord safety, and component deviation tolerance ranges.
