JVC KD-X310BT - Store Contact in Memory; Make Call from Memory; Delete Contact from Memory; Bluetooth Mode Settings

17
ENGLISH |
BLUETOOTH®
Store a contact in memory
You can store up to 6 contacts.
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [RECENT CALL] , [PHONEBOOK] , or
[DIAL NUMBER] , then press the knob.
3 Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4 Press and hold one of the number buttons (1 to 6).
“MEMORY P(selected preset number)” appears when the contact is
stored.
To erase a contact from the preset memory, select [DIAL NUMBER] in
step
2 and store a blank number.
Make a call from memory
1
Press to enter Bluetooth mode.
2 Press one of the number buttons (1 to 6).
3 Press the volume knob to call.
“NO PRESET” appears if there is no contacts stored.
Delete a contact
Not applicable for mobile phone that supports PBAP.
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [RECENT CALL] or [PHONEBOOK] , then
press the knob.
3 Turn the volume knob to select a contact or a phone number.
4 Press and hold PTY.
5 Turn the volume knob to select [DELETE] or [DELETE ALL] , then press
the knob.
DELETE : Selected name or phone number in step 3 is deleted.
DELETE ALL : All names or phone numbers from the selected menu in
step
2 is deleted.
6 Turn the volume knob to select [YES] or [NO] , then press the knob.
Bluetooth mode settings
1
Press and hold MENU.
2 Turn the volume knob to select [BLUETOOTH] , then press the knob.
3 Turn the volume knob to make a selection (see the following table),
then press the knob.
4 Press MENU to exit.
To return to the previous setting item or hierarchy, press PTY.
Default:
XX
PHONE
Selects the phone or audio device to connect or disconnect.
“
” appears in front of the device name.
AUDIO
APPLICATION
Shows the connected phone name using the JVC Smart Music Control *
1
app. “
” appears in front of the device name.
DELETE PAIR 1 Turn the volume knob to select a device to delete, then press the
knob.
2 Turn the volume knob to select [YES] or [NO] , then press the knob.
PRIORITY Selects a device to be connected as priority device. “ ” appears in front
of the device name set as priority.
•
“NO PAIR” appears if there is no registered device found.
P.BOOK WAIT *
2
Copies up to 400 numbers from the phonebook memory of a connected
phone.
SET PINCODE
(0000)
Changes the PIN code (up to 6 digits).
1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
Repeat steps
1 and 2 until you finish entering the PIN code.
3 Press the volume knob to confirm.
*
1
JVC Smart Music Control is designed to view JVC car receiver status
and perform simple control operations on Android smart phones.
For JVC Smart Music Control operations, visit JVC website:
<http://www.jvc.net/cs/car/>.
*
2
Selectable only when the connected phone supports OPP.