JVC KD-XD28BT - Getting Started with Your Device; Initial Setup and Configuration

ENGLISH
5
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Getting Started
Acknowledge the crossover type and cancel the
demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES] , see page6), the display shows: “2-WAY X’OVER” or “3-WAY X’OVER”
“PRESS” “VOLUME KNOB” “TO CONFIRM”.
1 Press the volume knob to acknowledge the current crossover type.
Then, the display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”.
• To change the crossover type, see page23.
2 Press the volume knob.
[YES] is selected for the initial setup.
3 Press the volume knob again.
“DEMO OFF” appears.
Set the clock and date
1
Press and hold .
2 Turn the volume knob to select [CLOCK] , then press the knob.
To adjust the clock
3 Turn the volume knob to select [CLOCKADJUST] , then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Set the time in the order of “Hour” “Minute”.
5 Turn the volume knob to select [CLOCK FORMAT] , then press the knob.
6 Turn the volume knob to select [12H] or [24H] , then press the knob.
1
2
To set the date
7 Turn the volume knob to select [DATESET] , then press the knob.
8 Turn the volume knob to make the settings, then press the knob.
Set the date in the order of “Day” “Month” “Year”.
9 Press to exit.
To return to the previous setting item, press
.
Set the basic settings
1
Press and hold .
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
.
Default: [XX]
[SYSTEM]
[KEY BEEP]
(Not applicable when 3-way crossover is selected.) (Page 23)
[ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]*1
[ON]: Enables AM in source selection. ; [OFF]: Disables. (Page 6)
[BTAUDIO SRC]*1
[ON]: Enables BT AUDIO in source selection. ; [OFF]: Disables.
(Page 21)
[BUILT-IN AUX]*1
[ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 10)
*1 Not displayed when the corresponding source is selected.
3
KD-X38MBS_K_B5A-3840-00_EN_1st Draft.indd 5KD-X38MBS_K_B5A-3840-00_EN_1st Draft.indd 5 23/8/2021 4:47:08 PM23/8/2021 4:47:08 PM