JVC KD-XD28BT

14
ENGLISH
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
JVC Remote Application
You can control the JVC car receiver from the following device using
JVC Remote application.
• KD-X38MBS: iPhone/iPodtouch (via Bluetooth or via USB input terminal) or
Android device (via Bluetooth)
• KD-X280BT/KD-XD28BT/KD-SX27BT: Android device (via Bluetooth)
For more information, visit <https://www.jvc.net/cs/car/>.
Preparation:
Install the latest version of JVC Remote application on your device before
connecting.
Start using JVC Remote application
1
Start up the JVC Remote application on your device.
2 Connect your device.
• For Android device:
Pair the Android device with this unit via Bluetooth. (Page15)
• For iPhone/iPodtouch:
Connect iPhone/iPodtouch to the USB input terminal. (Page8)
(or)
Pair the iPhone/iPodtouch with this unit via Bluetooth. (Page15)
(Make sure the USB input terminal is not connected to any device.)
3 Select the device to use from the menu.
See the following “Settings to use JVC Remote application”.
For KD-X38MBS: By default, [ANDROID] is selected. To use iPhone/
iPodtouch, select [YES] for [IOS] .
Settings to use JVC Remote application
1
Press and hold .
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
.
Default: [XX]
[REMOTE APP]
[SELECT] (For KD-X38MBS)
Selects the device ([IOS] or [ANDROID]) to use the application.
[IOS]
[YES]: Selects iPhone/iPod touch to use the application via Bluetooth or
connected via USB input terminal. ; [NO]: Cancels.
If [IOS] is selected, select iPod BT source (or iPod USB source if your iPhone/
iPod touch is connected via USB input terminal) to activate the application.
• The connectivity of the application will be interrupted or disconnected if:
– You change from iPod BT source to any playback source connected via the
USB input terminal.
– You change from iPod USB source to iPod BT source.
[ANDROID]
[YES]: Selects Android device to use the application via Bluetooth. ;
[NO]: Cancels.
[ANDROID
LIST]
Selects the Android device to use from the list.
• For KD-X38MBS: Displayed only when [ANDROID] of [SELECT] is set to [YES].
[STATUS] Shows the status of the selected device.
For KD-X38MBS: [IOS CONNECTED]: You are able to use the application using the
iPhone/iPod touch connected via Bluetooth or USB input terminal.
For KD-X38MBS: [IOS NOT CONNECTED]: No iOS device is connected to use the
application.
[ANDROID CONNECTED]: You are able to use the application using the Android
device connected via Bluetooth.
[ANDROID NOT CONNECTED]: No Android device is connected to use the
application.
KD-X38MBS_K_B5A-3840-00_EN_2nd Draft.indd 14KD-X38MBS_K_B5A-3840-00_EN_2nd Draft.indd 14 12/10/2021 10:56:54 PM12/10/2021 10:56:54 PM