JVC KW-M180DBT - Learning Function of Steering Remote; Reverse with ATT

12
External Components
Ñ To adjust the parking guidelines
✎ NOTE
• Install the rear view camera in the appropriate
position according to the instruction manual
supplied with the rear view camera.
• When adjusting the parking guidelines, make sure
to apply the parking brake to prevent the car from
moving.
1 Press the < > button.
2 Touch [ ].
3 Touch [System].
4 Touch [T] or [U] of [Parking Guidelines] and set
to [ON].
5 Touch [Guidelines SETUP].
6 Adjust the parking guidelines by selecting the
[ ] mark.
7 Adjusting the position of the selected mark.
A
B
C D
Make sure that lines A and B are horizontally
parallel, and that lines C and D are of the same
length.
✎ NOTE
• Touch [Initialize] and then touch [Yes] to set all the
marks to their initial default position.
Learning function of steering
remote
This function is available only when your vehicle
is equipped with the electrical steering remote
controller.
1 Press the < > button.
2 Touch [ ].
3 Touch [System].
4 Touch [Steering Remote].
5 Touch the function you want to set.
6 Press and hold the steering remote controller
button.
✎ NOTE
• You can have the unit learned all buttons at a time.
In that case, press the all buttons one at a time and
after pressing all of them, touch [6] in Steering
Remote Controller Setting screen.
7 Repeat steps 5 and 6 as necessary.
8 Touch [6].
✎ NOTE
• Touch [Initialize] and then touch [Yes] to set all the
settings to the initial default settings.
Reverse withATT (-20dB)
When the gear is shifted to the reverse (R) position,
the volume of the device is adjusted.
1 Press the < > button.
2 Touch [ ].
3 Touch [System].
4 Touch [Reverse with ATT].
5 Touch [T] or [U] set to [ON]/[OFF].
✎ NOTE
• The setting value is ON (default)