JVC KW-V250BT - Remote Controller; Preparation

SettingsSettings
2
Select an item (1) you want to display in
the selected menu, then touch [ × ] to set
(
2).
FNC
-
Settings
Key1
Key Customize
Key1 Customize
Settings
Car Setting
Fader / Balance
Sound Effect
Equalizer
3 Repeat steps 1 and 2 to replace the other
menus.
Remote Controller Remote Controller
Remote controller RM-RK258 is supplied for
KW-V350BT Region 4.
• For KW-V250BT/KW-V25BT/KW-V350BT Region1:
To use the remote controller, purchase optional
remote controller, RM-RK258.
Refer to the instruction manual supplied with the
remote controller.
• For KW-V350BT Region 4: The unit is equipped
with a steering wheel remote control function.
(Page48)
– See page 55 for connection.
– Operations may differ depending on the type of
steering wheel remote control.
* DO NOT expose the remote sensor to bright
light (direct sunlight or artificial lighting).
Remote sensor*
Preparation
Removing the battery sheet
Pull the battery sheet out from the remote controller
to activate the battery.
Changing the battery of the remote
controller
CR2025 (+side)
• Use a commercially available button battery
(CR2025).
• Insert the battery with the + and – poles aligned
properly.
– If the effectiveness of the remote controller
decreases, replace the battery.
CALIFORNIA, USA ONLY
This product contains a CR Coin Cell Lithium Battery
which contains Perchlorate Material — special
handling may apply. See <www.dtsc.ca.gov/
hazardouswaste/perchlorate>.
50
ENGLISH
00_KWV_2019ST_KR.indb 5000_KWV_2019ST_KR.indb 50 1/6/2018 8:19:22 AM1/6/2018 8:19:22 AM