SettingsSettings
2
Select the speaker type (1), select the size
of the selected speaker (
2), then display
the <X’over> screen (
3).
• If no speakers are connected, select <None>.
• When setting the front speakers, also select the
speaker size for <Tweeter>.
3 Adjust the crossover frequency of the
selected speaker.
• Adjustable items vary depending on the selected
speaker type/speaker size/crossover settings.
<TW Gain (L)>/<TW Gain (R)>
Adjusts the output volume of the tweeter (left/
right).
<TW FREQ>
Adjusts the crossover frequency for the tweeter.
<Gain>
Adjusts the output volume of the selected speaker.
<HPF FREQ>
Adjusts the crossover frequency for the front or rear
speakers (high pass filter).
3 To determine the adjustment value, see
“Determining the value for <Position DTA>
adjustment” on page 33.
To initialize the setting value: Touch [Initialize].
* <Front All> is selectable only when <X'over Network> is set to
[2way].
<Volume Offset>
Adjust and store the auto-adjustment volume level for
each source. If the source is a disc, the adjustment is
stored for each of the following categories:
• DVD/VCD
• CD
• DivX/MPEG1/MPEG2/MP3/WMA/WAV/AAC/FLAC
The volume level will automatically increase or
decrease when you change the source.
• –15 to +6 (Initial: 00)
<LPF FREQ>
Adjusts the crossover frequency for the speaker
(low pass filter).
<Slope>
Adjusts the crossover slope.
<Phase>
Selects the phase for the speaker.
<Time Alignment>
Make fine adjustments to the delay time of the speaker
output to create a more suitable environment for your
car.
Select the listening position (1), select
[Distance] or [Gain](
2) to make an
adjustment, then adjust each speaker setting
(
3).
1 Select from <All>, <FrontL>, <Front R> or
<Front All>*.
2 Select an item to adjust.
[Distance] Adjusts the digital time alignment
value.
[Gain] Adjusts the output volume of the
selected speaker.
32
ENGLISH
00_KWV_2019ST_EQ_EN.indb 3200_KWV_2019ST_EQ_EN.indb 32 29/6/2018 11:57:04 AM29/6/2018 11:57:04 AM
To Next Page
Loading...
