JVC KW-XR611 - Page 36

36 ENGLISH
Symptom Remedy/Cause
Bluetooth *
3
The unit does not make pairing
with the Bluetooth device.
• Enter the same PIN code for both the unit and
target device.
• Select the device name from “SPECIAL,” then try to
connect again. ( 14)
• Try to pair/connect from the Bluetooth device.
Echo or noise occurs. Adjust the microphone unit position.
Phone sound quality is poor. • Reduce the distance between the unit and the
Bluetooth mobile phone.
• Move the car to a place where you can get a better
signal reception.
The connected audio device
cannot be controlled.
Check whether the connected audio device
supports AVRCP (Audio/Video Remote Control
Profile).
The sound is interrupted or skipped
during playback of a Bluetooth
audio device.
• Reduce the distance between the unit and the
Bluetooth audio device.
• Disconnect the device connected for “BT-PHONE.”
• Turn off, then turn on the unit.
• Connect the Bluetooth audio device again, when
the sound is not yet restored.
iPod/iPhone
The iPod does not turn on or does
not work.
• Check the connecting cable and its connection.
• Update the firmware version of the iPod/iPhone.
• Charge the battery of the iPod/iPhone.
• Reset the iPod/iPhone.
• Check whether <IPOD SWITCH> setting is
appropriate (
27).
The sound is distorted. Deactivate the equalizer either on this unit or the
iPod/iPhone.
A lot of noise is generated. Turn off (uncheck) the “VoiceOver” feature of the
iPod. For details, visit <http://www.apple.com>.
Playback stops. The headphones are disconnected during playback.
Restart the playback operation (
18).
“CANNOT PLAY” appears on the
display.
No tracks are stored. Import tracks to the iPod/
iPhone.
“RESTRICTED” appears on the
display.
Check whether the connected iPod/iPhone is
compatible with this unit ( 32).
*
3
For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
EN30-39_KW-XR611_003A_1.indd 36EN30-39_KW-XR611_003A_1.indd 36 1/15/10 9:45:50 AM1/15/10 9:45:50 AM