English - 11 -
Connections
Connector Type Cables Device
Scart
Connection
(back)
VGA
Connection
(back)
SIDE AV(**)
PC/YPbPr
Audio
Connection
(side)
SIDE AV(**)
PC/YPbPr
Audio
Connection
(side)
Cable
HDMI
Connection
(back)
SPDIF(**)
SPDIF
(Optical Out)
Connection
(back)
SPDIF(**)
SPDIF
(Coaxial Out)
Connection
(back)
SIDE AV(**)
Side AV
(Audio/Video)
Connection
(side)
AV Cable
SIDE AV(**)
Side AV
(Audio/Video)
Connection
(side)
Cable
HEADPHONE
Headphone
Connection
(side)
YPBPR
YPbPr Video
Connection
(back)
USB
Connection
(side)
CI
Connection
(side)
CAM
module
NOTE: When connecting a device
via the YPbPr or Side AV input, you
must use the connection cables to
enable connection. See the illustrations
on the left side. | You can use YPbPr
to VGA cable to enable YPbPr signal via
VGA input. | You cannot use VGA and
YPbPr at the same time. | To enable PC/
side audio inputs with a YPbPr/PC
audio cable for audio connection. | To
use the Side AV input with a YPbPr/
. | If an external device
TV will automatically switch to AV mode.|
When receiving DTV channels (Mpeg4
output will not be available via the scart
socket. | When using the wall mounting kit
plug all your cables into the back of the
TV before mounting on the wall. | Insert or
remove the CI module only when the TV
is SWITCHED OFF. You should refer to
the module instruction manual for details
of the settings. | The/Each USB input of
your TV supports devices up to 500mA.
Connecting devices that have current value
above 500mA may damage your TV. | By
have to use only a shielded HDMI cable
parasitic frequency radiation.
them.
(**) If this feature is supported by your TV
To Next Page
Loading...
