2
10
Preparation
Front View and Bottom View Controls
Item Description
1 POWER LED
Illuminates red when the TV is in standby mode. The LED will blink in red, confirming
that a timer recording programme has started in standby mode.
2 IR (Infrared Receiver)
Receives IR signals from the remote control.
Do not put anything near the sensor, as its function may be affected.
3 Joystick Function Button
• In STANDBY mode, press to switch the TV on from standby mode.
• In ON mode, press and hold then select "Yes" and press again to switch the TV back
to standby mode.
• Press to display the input sources menu.
• Move up and down (
/ ) to select a channel or select among different input
signal sources.
• Move left and right (+ / –) to adjust the volume or access the selection on the input
source menu.
1 2
3
To Next Page
Loading...