8
Disconnecting the stand
1) Place the TV face down on a soft cloth on a table.
2) Remove the five screws from the back of the TV.
3) Pull out the stand from the TV.
Note:
• To re-install the stand, reverse the procedure from 3) to 1).
Precautions
Tidying the cables
A cable holder which keeps your connection cables
tidy is attached to the back of the stand.
Install your TV
To prevent the TV from falling, thread the belt
through the hole on the back of the standand
secure it to the TV rack.
Belt and screw (not included)
Hole
LCT2403-001A-A English.indd 8LCT2403-001A-A English.indd 8 5/2/08 9:58:56 AM5/2/08 9:58:56 AM
To Next Page
Loading...
Need help?
General
