E12
Setup
3-3. Removing the transport protective materials
After opening the transport lock, proceed to the following steps without closing the door.
1.
Remove magazine No. 1.
(
a
See “9-1. Ejecting/loading the magazines” on page E27.)
2.
Pull out the protective material forwards.
3.
Load magazine No. 1.
(
a
See “9-1. Ejecting/loading the magazines” on page E27.)
4.
Repeat the same operation for each of the remaining magazines.
TOP
TOP
Protective material
3 4
2
• In the case of re-transporting, it is necessary to remove all the discs and re-attach the protective transport materials
using the reverse procedure to the above. When this operation is required, please consult your dealer or nearest JVC-
authorized service agent.
To Next Page
Loading...
