JVC MX-J270V

MX-J270V
1-10
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly and the voltage selector.
Disconnect the harness from connector CN901A and
CN901B on the inside of the main board.
Cut off the tie band j of the power transformer
assembly and unsolder the power cord.
(Make sure to bundle the wires after repair.)
Remove the four screws O attaching the power
transformer assembly.
When removing the power transformer assembly
with the power cord, remove the rear panel and pull
out the power cord stopper from the bottom chassis
upward.
1.
2.
3.
Removing the power transformer
assembly
(See Fig.20 to 22)
Fig.20
Fig.21
Fig.22
O
Power transformer assembly
CN901A,CN901B
O
Power transformer
assembly
Tie band j
Power transformer
assembly
Power cord stopper
Rear panel
Voltage selector board
Voltage selector board
Voltage selector board
Video board
Video board
Front panel
assembly