MX-J270V
1-8
Prior to performing the following procedures, remove
the metal cover and the CD changer mechanism
assembly.
It is not necessary to remove the front panel
assembly.
Remove the two screws F and the rear cover on the
back of the body.
Remove the four screws G and the seven screws H
attaching the main board and the heat sink to the
rear panel.
Remove the screw I attaching the rear panel to the
chassis base.
Remove the two screws J attaching the rear panel to
the voltage selector.
Remove the two screws K attaching the rear panel to
the video board.
Release the lower two joints f and g on both sides of
the rear panel using a screwdriver and detach the
rear panel backwards.
1.
2.
3.
4.
5.
6.
Removing the rear cover, the rear panel,
the voltage selector and the video board
(See Fig.12 to 15)
Fig.12
Fig.13
Fig.14
Fig.15
I
Rear panel
G
Rear panel
F
F
Rear cover
H
G
H
Rear panel
Joint f
Rear panel
Joint g
(To Earth bracket)
J
K
To Next Page
Loading...
Need help?
General
