JVC NX-F40 - Page 23

Listening to FM radio
18
You can refer to Radio Data System information in
the display window while listening to an FM radio
broadcast.
■ When listening to an FM radio broadcast
Press [DISPLAY] repeatedly.
• The information is changed as follows.
PS (Program Service):
While the main unit is searching for Radio Data
System information, “WAIT PS” appears and then
the radio station name is displayed in the display
window. “NO PS” appears if no signal is received.
PTY (Program Type):
While the main unit is searching for Radio Data
System information, “WAIT PTY” appears and then
the type of the broadcasted program is displayed
in the display window. “NO PTY” appears if no
signal is received.
RT (Radio Text):
While the main unit is searching for Radio Data
System information, “WAIT RT” appears and then
text messages sent by the radio station are
displayed in the display window. “NO RT” appears
if no signal is received.
NOTE
• If the main unit takes time to show the Radio
Data System information received from a radio
station, “PS”, “PTY” or “RT” may appear in the
display window.
• When PS, PTY or RT signals appear in the
display window, special characters and symbols
may not be displayed correctly.
You can locate a type of radio program by
specifying the corresponding PTY code.
The PTY search is applicable only to the preset
radio stations.
■ When an FM radio broadcast is selected as
the source
1 Press [PTY SEARCH].
Display on the main unit
2 Press [ PTY SELECT] or [PTY
SELECT ] repeatedly to select a
PTY code while “PTY SELECT” is
flashing in the display window.
Example:When “DOCUMENT” is selected
as a PTY code
• Refer to page 19 for the PTY codes.
3 Press [PTY SEARCH].
• While the main unit is searching for a radio
program, “SEARCH” and the selected PTY
codes are displayed in the display window.
Example:When “DOCUMENT” is selected
as a PTY code
• The main unit searches 30 preset FM radio
stations, and stops when the main unit finds
the one you have selected. At this time the
selected frequency and PS code flash.
To search for the next radio station, press
[PTY SEARCH] while the selected
frequency and PS code are flashing. After
the frequency and PS code stop flashing or
if a button is pressed, the main unit
automatically tunes in to the selected radio
station.
• To stop searching, press [PTY SEARCH] or
[CANCEL].
• If no program is found, “NOTFOUND”
appears in the display window and the main
unit returns to the last received radio station.
Changing the Radio Data System
information
PTY RTPS
(Non-Radio Data System signal)
Frequency
Searching for programs by PTY
codes (PTY search)
For the locations of the remote
control buttons, refer to page 16.
NX-F40_NX-F30[B].book Page 18 Wednesday, December 24, 2008 10:04 AM