JVC NX-F40 - Operating a VCR Using the Remote Control

51
Operating other equipment
5 Release [STB/VCR F].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change
without notice. You may not be able to operate
the STB produced by the manufacturer.
• After replacing the batteries of the remote
control, set the manufacturer code again.
Before the STB operation, select the remote
control mode for the STB.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [STB].
2 Operate the remote control by
pointing it at the STB.
NOTE
• When the remote control mode selector is slid to
the lowest position and [STB] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [VCR].
2 Hold down [STB/VCR F].
• Hold down [STB/VCR F] until you finish
step 5.
3 Press [ENTER].
4 Press number buttons to enter the
manufacturer code.
Examples:
For a Hitachi VCR: Press [0], then [8].
For a Toshiba VCR: Press [3], then [3].
When the manufacturer of your VCR has 2 or more
codes, enter the manufacturer codes in turn and
find the one that operates the VCR and the remote
control properly.
The initial code setting is “01 (JVC)”.
Remote control button Usage
[STB/VCR
F]
Turns on/off the STB.
[CH +/ – ] Changes channels.
Number buttons (1-9, 0,
10)
Selects the channels.
Using the remote control for the
STB operation
Operating a VCR using the
remote control
Manufacturer Code Manufacturer Code
JVC 01 Nokia 16
Aiwa 02, 20 Nordmende
17, 18, 19,
31
Bell+Howell 03, 16 Orion 20
Blaupunkt 04 Panasonic 21
CGM 03, 05, 16 Philips 05, 22
Daewoo 34 Phonola 05
DIGTAL 05 Saba
17, 18, 19,
23, 31
Fisher 03, 16 Samsung 24, 25
G.E. 06 Sanyo 03, 16
Grundig 07 Sharp 26, 27
Hitachi 08, 09 Siemens 07
Loewe 05, 10, 11 Sony
28, 29, 30,
35
Magnavox 04, 05
Telefunken
17, 18, 19,
31, 32
Mitsubishi
12, 13, 14,
15
Toshiba 33
Setting the manufacturer code
Operating other equipment (continued)
NX-F40_NX-F30[B].book Page 51 Wednesday, December 24, 2008 10:04 AM