JVC NX-F40 - Operating an STB Using the Remote Control

50
Operating other equipment
5 Release [TV F].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change
without notice. You may not be able to operate
the TV produced by the manufacturer.
• After replacing the batteries of the remote
control, set the manufacturer code again.
Before the TV operation, select the remote control
mode for the TV.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [TV].
2 Operate the remote control by
pointing it at the TV.
.
NOTE
• When the remote control mode selector is slid to
the lowest position and [TV] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [STB].
2 Hold down [STB/VCR F].
• Hold down [STB/VCR F] until you finish
step 5.
3 Press [ENTER].
4 Press number buttons to enter the
manufacturer code.
Examples:
For an Amstrad STB: Press [0], then [3].
For a Triax STB: Press [3], then [0].
When the manufacturer of your STB has 2 or more
codes, enter the manufacturer codes in turn and
find the one that operates the STB and the remote
control properly.
The initial code setting is “01 (JVC)”.
(Continued on the next page)
Remote
control button
Usage
[TV
F]
Turns on/off the TV.
[TV/VIDEO]
Changes between the TV and
video input.
[CH +/
– ] Changes channels.
[TV VOL +/
– ] Adjusts volume.
Number
buttons (1-9, 0,
100+)
Selects the channels.
[TV RETURN]
Changes between the previously
selected channel and the current
channel.
Using the remote control for the TV
operation
Operating an STB using the
remote control
Manufacturer Code Manufacturer Code
JVC 01, 02 Mascom 32
Amstrad
03, 04, 05,
06, 31
Maspro 13
BT 01 Nokia 24, 26, 33
Canal+ 20 Pace 10, 25, 31
Canal Satellite 20 Panasonic 15
D-Box 24 Philips 09, 23
Echostar
17, 18, 19,
21
Saba 35
Finlux 11 Sagem 22, 29
Force 28 Salora 11
Galaxis 27 Selector 29
Grundig 07, 08 Skymaster 12, 36
Hirschmann 07, 17, 37 Thomson 35
ITT Nokia 11 TPS 22
Jerrold 16 Triax 30
Kathrein 13, 14, 34 Wisi 07
Luxor 11
Setting the manufacturer code
NX-F40_NX-F30[B].book Page 50 Wednesday, December 24, 2008 10:04 AM