– 40 –
Continued
About High-Speed Recording
There are some restrictions to observe for high-speed
recording (x2 speed recording: two times as quick as
normal speed recording, x4 speed recording: four times
as quick as normal speed recording) to protect
copyrights. (HCMS: see page 70.)
This unit is so designed that a song (track) recorded from
the built in CD player using high-speed recording cannot
be re-recorded until 74 minutes elapse after the previous
recording started.
If you try to re-record the same song (track) within the
74 minutes, recording is canceled and
“HCMS CANNOT COPY” appears as a warning.
The remaining time required until re-recording will then
appear in the main display.
If this happens, press 7 after the remaining time appears.
REMEMBER if you are trying to record a program or
the repeated playback including the same song (track)
twice using high-speed recording, recording will stop at
the beginning of the 2nd recording of the same song
(track). (“HCMS CANNOT COPY” will appear in the
main display.)
During high-speed recording
You cannot listen to any source, and therefore, cannot adjust the
volume level. (“CANNOT LISTEN!” will appear if you try to
do.)
About x4 speed recording
• You can select the x4 speed recording only when you select
SP as the recording length mode.
• When you select the x4 speed recording, you cannot record
using Program or Random play mode.
Adjusting the Recording Level
You can adjust the recording level when CD or the
equipment connected to LINE IN jacks or OPTICAL
DIGITAL IN terminal is selected as the source.
When the recording level is too high, “Level OVER!”
appears in the main display and the OVER indicator lights
up on the display.
• You cannot adjust the recording level when the source is
FM/AM (MW/LW).
Adjusting the Recording Level for CD
You can adjust the recording level only when you select
“x1 SPEED” as the recording speed.
1
Load a CD you want to record.
2
Press CD 3/8 to start playback.
3
Press REC SPEED on the remote control to select
“x1 SPEED.”
The x1 indicator lights up on the display.
4
Press REC LEVEL on the unit.
The recording level indication appears in the main
display.
• If “x1 SPEED” is not selected, “CANNOT ADJUST
REC LEVEL” appears in the main display.
5
Press VOLUME + or – on the unit repeatedly to
adjust the recording level from –12 dB to +12 dB by
2 dB steps.
• To decrease the level, press VOLUME – .
• To increase the level, press VOLUME + .
6
Press REC LEVEL on the unit to finish adjusting
the recording level.
7
Press 7.
The recording level will be reset to “0 dB (initial
setting)” when
• Finishing the recording
• Changing the recording speed (x1/x2/x4)
• Changing the source
• Ejecting MD or CD
• Turning off the unit (on standby)
EN37-44_CA-NXMD1R[B]f.pm6 01.8.20, 11:3440
To Next Page
Loading...
Need help?
General
