JVC PC-X110 - Cassette Relay Playback and Radio Reception; Relay Playback (Deck B to Deck A); Radio Reception and FM Mode Settings

PC-X110 B/E/G/GI/EN
(RELAY PLAYBACK ea
(From Deck B to Deck A)
Operate in the order shown
Set the POWER button to on.
Load a cassette tape in Deck B.
Load a cassette tape in Deck A.
Set the TAPE switch as required.
Press the ® PLAY button on Deck B.
Set Deck A to the play-pause mode.
When Deck B stops, Deck A’s pause mode will be
released and it will start playback. When Deck A stops
automatically, relay playback will be released.
Note:
Use the same type of tape in Decks A and B during this
mode.
(RADIO RECEPTION <
Operate in the order shown
@ Set the POWER button to on.
@ Press the TUNER/BAND button; a band and radio
frequency will be shown in the display.
®@ If the PLAY button of the deck is pressed, press the
STOP/EJECT (m/&) to set to the stop mode.
© Selectthe band/FM mode (FM auto, FM MONO or AM
(MWILW)).
@ Tune to the required station.
FM MODE button
Auto mode:
Set to this position when listening to or recording an FM
stereo broadcast. The STEREO indicator lights when a FM
stereo broadcast is received.
MONO:
Set to this position when FM stereo reception is noisy.
When another station is tuned to in the MONO mode using
the TUNING UP/DOWN or PRESET SCAN/AUTO PRESET
button, the unit automatically enters Auto mode.
(No, 1904) 15