JVC PC-X110 User Manual

PC-X110 B/E/G/GI/EN
© To stop a disc temporarily
Press the Ill button to stop play temporarily. When
pressed again, play resumes from the point where it was
paused.
Caution:
© To change discs, press the C/CLEAR button; check
that the disc has stopped rotating completely before
unloading it.
Notes:
© The following indication may be shown when a disc is
dirty or scratched, or when the disc is loaded upside
down.
In such a case, check the disc and insert again after
cleaning the disc or turning it over.
© Do not use the unit at excessive
temperatures. The recommended temperature
range is from 5°C (41°F) to 35°C (95°F).
©
After
playback,
unload
the
disc
and
close
the
Disc
holder.
if
mistracking
occurs
during
play,
lower
the
volume.
Mistracking
may
occur
if
a
strong
shock
is
applied
to
the
unit
or
if
itis
used
in
a
place
subject
to
vibrations
(i.e.
in
a car travelling on a rough road).
Skip playback
©
During
playback,
it
is
possible
to
skip
forward
to
the
beginning
of
the
next
tune
or
back
to
the
beginning
of
the
tune
being
played
or
the
previous
tune;
when
the
beginning
of
the
required
tune
has
been
located,
play
Starts
automatically.
To listen to the next tune ...
Press the Pi button once to skip to the beginning of the
next tune.
To listen to the previous tune ...
Press the + button to skip to the beginning of the tune
being played back and press again to skip to the beginning
of the previous tune.
Search playback (to locate the required position
on the disc)
© The required position can be located using fast-forward
or reverse search while playing a disc.
K@@ SEARCH DD}
Keep
pressing
for
fast-reverse
search
CI
>
Keep
pressing
for
fast-forward
search
Direct access playback (using the remote control)
© Pressing any of the track number buttons will start
playing from the beginning of the designated tune,
without your having to press the CD p/tt button. (This
function cannot be used during programmed play.)
@/CLEAR
12 (No. 1904)
© Hold down the button; search play starts slowly and
then gradually increases in speed.
© Since low-volume sound (at about one quarter of the
normal level) can be heard in the search mode, monitor
the sound and release the button when the required
position is located.
@ Press the @/CLEAR button to set to the CD mode.
© If the PLAY button of the deck A or B is pressed,
press the STOP/EJECT (m/#) button to set to the
stop mode
@ Designate the required tune using the track number
buttons.
To designate tune numbers 1 to 10, press the track
number button corresponding to the tune (track)
number.
© To designate tune number 11 or higher, press the
+10 button the required number of times, then the
track number button. (Example: To designate the
20th tune, press the +10 button once, then press
track number button 10.)
* +10 button:
Each time this button is pressed, the number increases by
10. First press this button to set the 10's digit, then press
the track number button to set the 1's digit.
© To skip to another tune during play
When the required track number button is pressed, the
display shows the designated track number and play
starts from the beginning of the designated tune.

JVC PC-X110 Specifications

General

Brand	JVC
Model	PC-X110
Category	CD Player
Language	English