JVC PC-X110 - Repeat and Random Playback Modes; Repeat Playback Modes (Single;All); Random Playback and Intro Scan; Cassette Playback Operations

PC-X110 B/E/G/GI/EN
Repeat play (using the remote control)
Press the REPEAT button while pressing the SHIFT button
before or during play. A single tune or all the tunes can be
repeated.
Whether a single tune or all tunes are to be repeated can
be specified. Each time the REPEAT button is pressed while
pressing the SHIFT botton the mode will change from a
single tune (c ), to all the tunes (= ALL), to the clear
mode, in this order.
S&S > S&S ALL > Goes off
Single tune All tunes:
ioe as mo a =
SHIFT REPEAT
© Repeat playback of a single tune (c) ©
The tune | being played back will be heard repeatedly. CASSETTE PLAYBACK ea
=
i
(The
example
shows
Deck
A)
rary st RS
wo a wht Operate in the order shown
© Repeat playback of all tunes ( ALL)
When playing back an entire disc or programmedtunes,
all tunes or the programmed tunes will be heard
repeatedly.
Random playback (using the remote control)
Press the RANDOM button while pressing the SHIFT button,
all tunes on a disc are played once, in random order.
Set the POWER button to on.
INTRO
scan
operation
(using
the
remote
contro!)
Load
a
cassette
tape
in
Deck
A.
*
Simply
press
the
INTRO
scan
button
while
pressing
the
SHIFT
button,
to
play
the
first
15
seconds
of
each
tune.
The
operation
is
released
after
playing
the
introductions
Press to start playback.
o
e
4 Set the TAPE switch as required.
© Adjust.
of all tunes or all programmed tunes. © Playback in Deck B
*
If
the
INTRO
scan
button
is
pressed
in
the
middle
of
a
The
previous
procedures
@
through
@
also
apply
to
tune
while
pressing
the
SHIFT
button,
the
intro
scan
Deck
8
when
a
cassette
is
loaded
in
Deck
B.
When
operation
will
start
from
the
next
tune.
Decks
A
and
B
are
simultaneously
set
to
the
play
mode,
*
To
release
the
intro
scan
mode,
press
the
INTRO
scan
only
the
playback
sound
of
Deck
B
is
heard.
button again while pressing the SHIFT button, and
normal playback (or programmed playback) will resume. Notes:
1.
When
the
power
is
turned
off
while
the
tape
is
still
running,
cassette
operation
buttons
which
are
depressed
do
not
return
to
the
original
positions.
Press
the
STOP/EJECT
(m/d)
button
to
stop
the
tape
running
before
turning
off
the
power.
2.
Avoid
operating
the
FF
or
REW
button
on
the
deck
during
playback
of
the
other
deck.
14 (No. 1904)