JVC PC-X110 - Synchronized CD Recording; Synchronized Recording Setup; Synchronized Recording Without Auto Spacing

PC-X110 B/E/G/GVEN
Synchronized recording with the CD player
© In this system, the CD player starts playback when
Deck A enters the recording mode.
Operate in the order shown
18 (No. 1904)
@ Load a cassette tape in deck A.
@ Load a disc and close the Disc holder.
© Set the CD mode.
@ When the PLAY button of deck is pressed, press
the STOP/EJECT (m/4) button to set to the stop
mode and perform this operation.
@ When programmed playback is required, program the
required tunes using the remote control. (See page
27.)
© Select tunes with a total playing time which does not
exceed the tape length.
© Press the © REC button with the » PLAY button;
synchronized recording will start.
© Non-recorded sections of approx. 4 seconds are
automatically left between tunes.
@ When the tape reaches the end first, the CD player
stops automatically; when the CD player stops first, the
tape continues running. In this case, press the m/&
STOP/EJECT button to stop the tape.
@ When automatic spacing between tunes is not
required ...
Perform the following after finishing the previous
operation (@ to @).
© Press the > PLAY/PAUSE button of the CD player
twice. The CD player enters the pause mode.
@® Press the OREC and m PLAY buttons simultaneously.
Now, the CD player starts playback simultaneously.
Note:
To record a compact disc, be sure to check that the
track (tune) number and playing time are displayed
‘on the display window before pressing the OREC
button and » PLAY button.