JVC PC-X95B User Manual

| PC-X95secene
DUBBING
(SYNCHRO
START
DUBBING)
Normal
and
high-speed
dubbing
can
be
done
from
deck
B
to
deck
A.
Operate in order shown... .
3] Set to NORMAL SPEED or HIGH SPEED DUBBING. Set to correspond to the type of tape in deck B.
[FUNCTION]
Press the © REC and ® PLAY buttons simultaneously.
Va Press the PLAY button.
(Record-pause mode)
(Synchronized dubbing will start.)
Press the &8 PAUSE button.
Load a cassette.
(Refer to the note on page 30)
Notes: ;
1. Television receivers placed close to this unit may cause
interference on the recorded signal when this unit is used
in the high-speed dubbing mode. If this happens, either
turn off the television receiver or use the normal-speed
dubbing mode.
2. With deck A in the record-pause mode, the 8 PAUSE
button is released when deck B enters the stop mode.
3. Avoid switching the FUNCTION switch during dubbing.
tt PAUSE button Erasing
First of all, press the #l PAUSE button. Then, press the O
When recording on a prerecorded tape, the previous recording
REC and ® PLAY buttons, thus entering the record-pause
is automatically erased and only the new program is recorded
(standby) mode. After that re-press the §§ PAUSE button at on the tape.
the exact moment you want to start recording. This releases To erase a tape without making a new recording...
the tape to begin recording at a precise moment. Follow the section “RECORDING” but in step @, set the
e@Do not.leave the unit in pause mode for more than a few FUNCTION. switch to TAPE then perform recording to
minutes.
Instead,
push
the
Ls
/&
STOP/EJECT
button
erase
a
tape.
and turn the power off.
Full auto-stop mechanism (both decks A and_B)
When the tape reaches either end during the recording/
playback and fast forward or rewinding mode, the tape
stops automatically.
(No. 1859) 13

JVC PC-X95B Specifications

General

Brand	JVC
Model	PC-X95B
Category	CD Player
Language	English